Messages

1

FAQs / Re: Motors does not respond! HELP!

« on: July 27, 2013, 09:29:49 AM »

Here I am again with the same problem :/ but now with new question. How i look, PC and driver is ok, so i think the problem are in step motors. Is there some way to check step motors?

Anyway i will explain what is happen. Whan i start machine(when i press butten RESET) i hear motors how working, but the problem is when i tray to move every single axis. Z work but wery hard, X and Y works for few millisecond and then X and Y are dead, they not respond even i press RESET. Maybe are step motors dead?

Thank you Milan.

2

FAQs / Re: Motors does not respond! HELP!

« on: September 04, 2012, 01:05:45 PM »

I` m not sure for version.... i see somewhere is 1.83.027 i don`t now where to look... I buy driver from elektronika.rs.ba they need to have english version... there is link http://www.elektronika.rs.ba/data/projekti/cnc/elektronika_v3.shtml

3

FAQs / Re: Motors does not respond! HELP!

« on: September 03, 2012, 06:17:24 AM »

How i see verison of the Mach is 1,02. I did how you said but X and Y axis still can`t run.
Do you know some ways how to check my driver? Maybe is driver in damage...

4

FAQs / Re: Motors does not respond! HELP!

« on: September 03, 2012, 03:52:02 AM »

Version of Mach is 3.
Times vary between +4.1 and +5.9 and Pulse Frequncy is 23692.
I use onborad parallel port (LPT1).

5

FAQs / Re: Motors does not respond! HELP!

« on: September 02, 2012, 12:28:45 PM »

There is my xml..

6

FAQs / Re: Motors does not respond! HELP!

« on: September 02, 2012, 10:19:44 AM »

Step Port and Dir Port was on ''0'' and i set on ''1'' but then only Z axis work. Another two X and Y does not work.
There is picture of configurations. http://www.sendspace.com/file/prm3vh

Thank you Hood for reply.

7

FAQs / Motors does not respond! HELP!

« on: September 01, 2012, 10:57:30 AM »

Hi guys!
I have problems with motors on my CNC machine. When i press button RESET i hear motors how they working but when i try to move they not respond. In Mach3 show me how coordinates are changing but my machine stay in place. In past this machine was working correctly and after reinstalling system on PC i have this problem. I can post pictures of settings if that can help.

PS. Sorry for my english

Thank you Milan.