Hello Guest it is November 22, 2019, 02:38:26 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jshonk

Pages: 1
1
Promote and discuss your product / Re: Learn the truth about BobCAD-CAM
« on: February 27, 2013, 11:17:41 AM »
 Aldepoalo
This V25 is messed up in my computer. It will run good in the simulation but not in Mach3, 4th axis only. Also the top menu bar with File, Edit, and all the stuff on that line + help is gone now I can't even use the help, maybe I wore it out. Can you help me? I can not afford the the 1 year thing with support from BobCad.
Thank you Jerry Honkanen

2
Finished Plugins for Download / Re: Huanyang VFD controller plugin
« on: October 05, 2012, 12:09:31 PM »
I don't know how to work this post thing. But I did get this problem fixed I dumped the whole thing and added extunnal controlls. All is good

3
Finished Plugins for Download / Re: Huanyang VFD controller plugin
« on: September 25, 2012, 12:12:31 PM »
The Huanyang VFD controller plugin is working Mach 3 sees it and when I try to run a program it will start to work The spindle will run at the right rpm and it will start to cut. When I get to the tool change M05 it stops Mach 3 NOT THE SPINDLE. I check and Mach3 doesn't see the controller any more (99 and 99). In order to get it to go I have to turn off Mach3 unplug the usb to the controller and start all over. Can this be fixed?

4
Finished Plugins for Download / Re: Huanyang VFD controller plugin
« on: September 18, 2012, 08:57:09 PM »
Huanyang VFD Mach3 Plugin
 It works good untill a tool change then I GET A FAULT (This action cannot complete because the other program is busy. Choose Switch to to actuate the busy program and correct the problem.) The only way it will shut down is to unplug the USB to rs485 cable.
I cannot figure out how to fix this.

Pages: 1