1
General Mach Discussion / Re: cnc mill "stottering"
« on: August 19, 2012, 04:25:45 AM »
hey
i did the driver test and it says "pulsing too fast". I had set the parameters on 25kHz, however the value in the box "pulses per second" is about 15000. i dont really know how to read this result...
Anyway after that I did a fresh install of Windows XP with nothing installed except Mach3. But it still says "pulsing too high"
is there anything I could try to do?
i did the driver test and it says "pulsing too fast". I had set the parameters on 25kHz, however the value in the box "pulses per second" is about 15000. i dont really know how to read this result...
Anyway after that I did a fresh install of Windows XP with nothing installed except Mach3. But it still says "pulsing too high"
is there anything I could try to do?