Hello Guest it is March 29, 2024, 02:20:02 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - wordperfect

Pages: 1
1
General Mach Discussion / Re: how to set up 2 probe inputs?
« on: September 11, 2017, 04:04:53 PM »
Thanks for answer, but I wired every think OK and working well.
Only need setup movable probe somewhere near spindle on Z axis on something as actuator to push down probe lover then spindle, measure, then pull up higher then spindle.

2
General Mach Discussion / Re: how to set up 2 probe inputs?
« on: September 06, 2017, 03:21:18 AM »
Hello,
I have fixed tool setter on machine, and free movable pcb plate for measure top of material. Now I need instead that movable pcb to fix new kind of setter on Z axis, and pull down and up with some drive (servo, magnet, or whatever better you know). Can anybody help me to realise this
Thanks

3
Finished Screens / Re: Mach3 6 axis screensets for serbians
« on: June 23, 2015, 06:41:23 AM »
imas epostu

4
Finished Screens / Re: Mach3 6 axis screensets for serbians
« on: June 23, 2015, 06:32:46 AM »
Beograda

5
Finished Screens / Re: Mach3 6 axis screensets for serbians
« on: June 17, 2015, 02:00:37 AM »
to verovatno znači da na tvom kompjuteru ili konektorima na paralelnom portu nije sve podešeno kako treba.Verovatno si neke zice spajao onako u vezduhu ka konektoru

6
Finished Screens / Re: Mach3 6 axis screensets for serbians
« on: June 14, 2015, 04:53:38 PM »
Nisam najbolje skapirao, ali, kada se pritisne dugme za pipalicu u nekom pravcu brojevi na DRO ekranu treba da se menjaju sve do kontakta kada treba da se upali signalna lampica.

7
Finished Screens / Re: Mach3 6 axis screensets for serbians
« on: June 11, 2015, 05:52:30 AM »
Sve radi nego treba podesiti prema svakoj masini. Evo mozda sada proradi. Presnimiti postojeci fajl ovim

pozdrav

8
Finished Screens / Mach3 6 axis screensets for serbians
« on: March 20, 2015, 02:41:00 AM »
These are screens for my 6 axis machines. I've made for my needs. I think it will be helpful. Unpack and just copy the files to C:\Mach3 folder and under menu View > Load screen open 6 osa boki.set or boki.set

Regards
Boban

Ovo su ekrani za moje 6 osne masine pravljene za moje potrebe i mozda ce biti od pomoci

9
It works. Thank you so much

10
Could someone tell me which is the keyboard shortcut for the A, B, C axis, the spindle reset and feed reset in the program Mach3 newer version. I tried all the buttons on the keyboard and combination with CTRL ALT but I can not start A axis. It works with the jog screen and MDI command, but I want to move it by pressing key for A axis like X axis.

Thanks in advance

Pages: 1