Messages

1

General Mach Discussion / Re: Controlling Mach3 With Robot

« on: August 07, 2012, 04:22:09 PM »

yes I have it figured out dos code prompt $_loop

2

General Mach Discussion / Re: Controlling Mach3 With Robot

« on: August 07, 2012, 02:32:59 PM »

I have discovered that it is thru a dos command that it can be achieved thanks for the input! -dcw

3

General Mach Discussion / Controlling Mach3 With Robot

« on: August 07, 2012, 09:18:07 AM »

My Company recently purchased a Bench top mill to "degate" molded parts the software and degating station all tested out and runs great in the Mill. my question is does anyone know how to tie in a Sepro Robot to tell my PC (Mill) cycle start and for the robot to know that when Program hits M30 that the degating station is ready for the next set of parts to degate??? any help would be greatly appreciated thanks - dcw@druckerco