Messages

1

CS-Lab / Re: CSMIO/IP-S Problems

« on: July 21, 2014, 10:12:24 AM »

INTERESTING STORY..... NEW PLUGIN-JUST LIKE THAT.... SO, I GUESS IF I WAIT AND WAIT YEARS I CAN JUST FORGET ABOUT ALL THIS AND TIME TO RETIRE...HA HA HA...

I AGREE CS-LAB SERVICE IS LACKING AND REPLYS I RECEIVE TO MY PERSONAL EMAIL ARE RUDE AND DO NOT ANSWER THE ORIGINAL QUESTION..

2

CS-Lab / Cs-Lab with CandCnC with Mach 3 FOR PLASMA use only

« on: July 21, 2014, 12:29:39 AM »

Anyone here use CandCNC for Plasma use with CS_LAB, IPA or IPS control and Mach 3 ?... Bugs, problems ?....

as in:

Mach 3
Cs-Lab controller
CandCNC Bladerunner , dragon cut

What I am asking is Omitting CandCNC controller with Cs_lab controller

3

CS-Lab / mach 4 use with cs lab

« on: September 18, 2013, 12:36:23 AM »

Andrew (CS LAB) or anyone know or familiar that IP/S OR IP/A works fine with Mach 4 ?.  I assume it should. Macros ?...


thanks all.................

4

General Mach Discussion / Re: KSI Labs Centipede Controler Board

« on: July 14, 2012, 11:14:12 PM »

THANKS FOR YOUR INPUT STEVE AND HOOD.... LET ME ASK, IS THE 100KHZ REALLY A PROBLEM ?.. HOW ABOUT DC BRUSH SERVOS THAT CAME WITH BOSTOMATIC MILL 1250 QUAD - DC MAX 70 VOLT- 1000 RPM MAX DIRECT FEED TO SCREWS ?... SINCE I NEVER HAD THE CHANCE TO RUN THIS MACHINE BEFORE STRIPPING IT I REALLY DON'T KNOW HOW IT PERFORMS.. YOUR COMMENTS APPRECIATED...AND THANK YOU..

KENT..

5

General Mach Discussion / Re: KSI Labs Centipede Controler Board

« on: July 14, 2012, 03:06:48 PM »

I WOULD ALSO LIKE TO KNOW WHO MIGHT BE USING KSI PRODUCTS AND OUTCOME...I EMAILED SERGEY AT KSI FOR INFO ABOUT DSP BOARD THAT IS COMPLETE WITH NO SOFTWARE YET AND MAYBE FOR A 1 YEAR WAIT...! 

I ALSO AM BUILDING NEW RETRO MACHINE BOSTO MILL...