1
General Mach Discussion / Re: Bridgeport Knee Mill Conversion?
« on: November 15, 2016, 03:19:27 PM »
Hi Dave,
I have used the recommended method with the Mach 3 whereby you go to settings page, do a run, and check out what is with what should be and set up to suit. I have found in use that that is way easier to do and likely more accurate (at anyrate with my maths!). I have used this for several years without accuracy problems. Worth trying before you get knee deep in numbers.
cheers, Dave.
I have used the recommended method with the Mach 3 whereby you go to settings page, do a run, and check out what is with what should be and set up to suit. I have found in use that that is way easier to do and likely more accurate (at anyrate with my maths!). I have used this for several years without accuracy problems. Worth trying before you get knee deep in numbers.
cheers, Dave.