Hello Guest it is June 19, 2019, 12:01:49 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - himpini

Pages: 1
1
VB and the development of wizards / Re: Macro for Rotary Tool Changer
« on: March 31, 2019, 06:07:10 PM »
Hi, sorry if I´m doing my question in a wrong way

I have a Takisawa Lathe working with Mach3
This lathe has te posibility to use 6 differents tools.
I´m working on a Macro to make a auto tool changer, but I´m a bit lost about how to do it.
The rotary tool works with the hydraulic system and not with a servomotor.
Here ther is a video to see how its works for a better understanding.

https://www.youtube.com/watch?v=ZEC7eSgKgsc

Could you help me with some Macro to check that could help me to finish my work?
Is there any document with help about Macros and examples?

Thanks

2
General Mach Discussion / Error during first cycle start
« on: July 14, 2013, 07:26:42 PM »
Hello, I have Mach 3 Version R3.043.066 installed, since a few days i have the next problem,
WHEN i start mach 3 in my PC the first time, I load the file and when press the cycle start button the machine goes to any where. Dont respect the file
When this happens I stop, I go to zero, and press again cycle start and work ok

Does someone  had the same problem?

Thanks  lot

3
General Mach Discussion / Mach Turn 3D Toolpath
« on: July 02, 2012, 06:15:50 PM »
Hello, I am using Mach Turn in a Takisawa Lathe, I cant see in the toolpath screen the 3D screen likes shows the manual.
Can anyone help me with this??

Thanks

Pages: 1