Messages

1

General Mach Discussion / Fixed

« on: June 18, 2012, 05:51:03 PM »

Fixed the problem

Thanks everyone

2

General Mach Discussion / Re: Losing position PLEASE HELP!!!!!

« on: June 14, 2012, 03:53:35 PM »

amazingly off

 off position .125" every 5 minutes

doesn't miss

every time

3

General Mach Discussion / Re: Losing position PLEASE HELP!!!!!

« on: June 14, 2012, 03:36:30 PM »

more info

two things
1. 5v power supply to drive
I have the ground attached to the chassis and power to drive pul+ and dir+
If I disconnect the - from the 5v the stepper starts moving slow

2. Power ground to the chassis

Question, if the neg- on 5v the same as chassis ground??

4

General Mach Discussion / Re: Losing position PLEASE HELP!!!!!

« on: June 14, 2012, 03:19:39 PM »

It loses position at any speed 200ipm and 20ipm

5

General Mach Discussion / Losing position PLEASE HELP!!!!!

« on: June 14, 2012, 01:35:32 PM »

As I'm running i loose position. Running simple toolpath +60" back to 0 on my Y axis, it's only loosing position going back to 0. About .125" every 2-5 minutes. What is going on?

Please someone help!!!