Messages

1

General Mach Discussion / Re: Need help can i flip the code design

« on: June 24, 2012, 07:22:59 PM »

Ok i think i got it - i set it to 90 and then did a test run not cutting but it looked like that will work as it ran the long way.

Thanks

2

General Mach Discussion / Re: Need help can i flip the code design

« on: June 10, 2012, 07:09:47 PM »

How do i
go into Maxh3 and swap the pin assignments for the two axis.  Make the long axis X and the short axis Y

I am not sure what to do and in what place

Thanks

3

General Mach Discussion / Need help can i flip the code design

« on: June 10, 2012, 05:55:06 PM »

Hi

I am designing things in V Carve and it it a pain in the butt to design something and then have to flip it all to cut on my CNC th see id side ways and have to re-line everything.

It is designed sideways but it can to cut in my cnc that way.

Can i do this in Mach 3 after i load in the code for the design some how?

My cnc cuts 20 wide by 30 long and my designs are 24 long by 7 to 10 tall so they need to be fliped to be able to cut down the 30 inch side of the cnc.

Can i load in the design code and just click on something in Mach3 to rotate the design before cutting it.

Thanks