Messages

1

Mach3 and G-Rex / Re: Mach3 Joggin Y & Z normally, X is slow like molasses

« on: June 03, 2012, 04:55:26 PM »

Okay, got this sorted (Duh!)

After putting my hand on the router and trying to feel the "pulse" of the reduced feed rate, I didn't feel it. I thought it had been moving, because Mach3 was showing the numbers change, and the increments had been so small I didn't notice before.

My cord was too tight and disconnected when I moved the access across my table. Duh!

-Newb on a Mission

2

Mach3 and G-Rex / Mach3 Joggin Y & Z normally, X is slow like molasses

« on: June 03, 2012, 04:42:01 PM »

I learned earlier how to jog using CTRL + J and have been alternating between functions today. The only problem is that my X axis now seems to be stuck on the slower jog rate. All my Motor Tuning is the same for the axises, and everything has worked well. Z & Y alternate fine between the speed rates.

Restarted Mach3, Rebooted computer, and checked all the jogging settings. My diagnostic screen is not showing any limits setup.

I can still set to the lower jog rate (and then everything moves the same speed). Why is just my X axis stuck on tortoise? Please help!

Appreciation in Advance...