Hello Guest it is November 28, 2020, 08:38:54 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - maxoliver

Pages: 1
General Mach Discussion / Re: Direction pulse
« on: May 31, 2012, 09:11:32 PM »
Hello Ian,

On the setup instruction you have first connected ENBL+ to 5V.

After you say: "Connect ENBL+ to ground for now.".

Should it be ENBL- to GND ?

I have the same driver and today could not make it work.



Pages: 1