Messages

1

General Mach Discussion / Re: Cutter Radius Compensation Error

« on: April 14, 2016, 02:08:01 PM »

I am using R3.043.066 version...

Which version are you using?

2

General Mach Discussion / Cutter Radius Compensation Error

« on: April 14, 2016, 05:47:01 AM »

Dear all,

I am using Mach3 Software in a Hot Wire Cutting Machine and the Mach3 is installed in a PC with Windows 7, 32 bit.

When the GCode loads, for most GCode programs  I am getting the following message: "Tool Radius greater than approach Line xx”.

I have attached the GCode for the MDP 41/4 which is loads without any error and the GCode for the MDP 20/4 loads with the above mentioned error.

Thank you very much for your time.

Best  regards,
George

3

G-Code, CAD, and CAM discussions / Hot Wire CNC Foam Cutter and GCode

« on: May 29, 2012, 03:09:37 AM »

Hello,

I am working at a factory where we have one Hot Wire CNC Foam Cutter. Some times the hot wire breaks and the operator, after replacing the hot wire, must manually enter the used tool and the last operating conditions in order the CNC foam cutter to operate normally from present position. Is there any way to start the CNC Foam Cutter with from present position the last operating conditions (Tool, Speed, Position etc) using GCode?

Thanks in advance,
George