Hello Guest it is March 29, 2024, 08:23:57 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - curtistactical

Pages: 1
1
the only pins that have numbers in them step pin and direction pin, you will have to forgive me this is all new to me i have never used mach3 or a parallel port for cnc, the step pin and dir pin are the only things that have numbers in them, I dont understand how it would know which way to go with only one dir pin number for each axis.

2
alright I have all the motors moving but they will all only move in the positive direction no matter if Im jogging it or running a program even if it thinks its moving negative it is actually still moving in the positive direction

3
hope someone can help me, I have a taig 2019 with geckodrive g540 controll I purchased from deep groove1 a couple months ago and I finally got time to set it up. I installed mach 3 , loaded the g540 xml and my license. I fought through most of the problems but now im stuck. under ports and pins all the drives have numbers 2-9 listed. the x axis will move but only one direction(will move with either jog key just in same direction), the z axis key makes the y axis jump around and the y axis jog keys do nothing. I have been running and programming haas funuc etc. machines for 15 years so I know about cnc's but this thing has got me so frustrated im about to sell it, any help or suggestions will be greatly appreciated.

Pages: 1