1
General Mach Discussion / Re: Z axis moves up 2 inches after I start G code start cycle
« on: May 19, 2012, 06:53:59 AM »
thanks for the replies. I checked gage block thickness and its set to .50 which is the actual thickness of block.
When I Z zero with auto zero function and then send machine to home all is well the bit rest on top of material
surface but when I start cycle bit jumps to 2 inch height then lowers to mill out height(.1250) and air cuts @
1.8750 above material
When I Z zero with auto zero function and then send machine to home all is well the bit rest on top of material
surface but when I start cycle bit jumps to 2 inch height then lowers to mill out height(.1250) and air cuts @
1.8750 above material