Hello Guest it is March 29, 2024, 02:34:56 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - K_Labs

Pages: 1 2 3 4 5 6 7 8 9 10 »
2
General Mach Discussion / Re: Kasuga NC mill to CNC ?'s
« on: April 01, 2019, 11:36:38 PM »
OK so I'm aback at it again. Need to make adapters for my encoder shafts to fit the resolver gears. 1/8 on the encoder and 1/4 on the resolver gear. Is it possible to do away with the resolver and tach and just replace it with the encoder? Hood told me it all depends on whether or not the NC400s require a tach signal.

3
General Mach Discussion / Re: Kasuga NC mill to CNC ?'s
« on: September 05, 2014, 05:00:26 PM »
Hey back again.... Took a extended break on the project because work got really busy. We managed to buy a VF2 in the mean time. Now I have some more free time and I want to pick up the project again. I just installed one of the encoders and it is working correctly. I have my signal wires on the board as well but I'm confused as to what else I need to get closer to the finish line. I have X Y and Z signal wires all coming out of a conduit along with a XE wire and I don't understand what it's for.

4
General Mach Discussion / Re: Kasuga NC mill to CNC ?'s
« on: August 29, 2012, 05:34:29 PM »
We just picked up an old bandit control for just under $200 that wasn't setup for a tool changer so now I can see what wires are needed for the axis an what r for the tool changer and get some progress happening.

5
General Mach Discussion / Re: Kasuga NC mill to CNC ?'s
« on: August 16, 2012, 07:32:59 PM »
Ok so I finally got the encoders in back to the project

6
General Mach Discussion / Re: Kasuga NC mill to CNC ?'s
« on: July 17, 2012, 11:07:07 AM »
I ordered encoders it's a 5 week wait time... I'm a week in.

7
General Mach Discussion / Re: Kasuga NC mill to CNC ?'s
« on: June 29, 2012, 01:37:36 AM »
I hooked up the signal wires to the KAnalog JP11. Z 0 & 1st ground Y 1 & 2nd ground X 2 & 3rd ground.


8
General Mach Discussion / Re: Kasuga NC mill to CNC ?'s
« on: June 29, 2012, 12:40:26 AM »
Pulled the bandit just now after I labeled everything.

9
General Mach Discussion / Re: Kasuga NC mill to CNC ?'s
« on: June 28, 2012, 08:24:19 PM »
Not a bad idea would that limit my capabilities at all?

10
General Mach Discussion / Re: Kasuga NC mill to CNC ?'s
« on: June 28, 2012, 05:46:58 PM »
I just found out my encoders have a 5 week lead time and cost $255 a pop. I think I might try to figure out something cheaper/faster. Any suggestions on encoders with similar features?

Pages: 1 2 3 4 5 6 7 8 9 10 »