1
Newfangled Solutions Mach3 Wizards / Re: Another Wizard Suggestion... Drill or Circular Pocket Option
« on: April 04, 2007, 11:28:56 AM »
Thanks for replying. I went ahead and loaded the lastest Mach3 2.0 in place of the 1.84 version.
This seemed to fix the hole pattern problem. There are a few other glitches in the Wizard that I've ran in this latest version, i.e. green preview screen, wouldn't approach correctly while trying to cut an outside circle. Would "spazz" out and lose steps, then continue on with the G-code. This happened after pressing the ESC botton to stop the previous program. Then the two issues mentioned above happened. These were minor, but worth mentioning, just in case anyone else has ran into these problems. WgE.
This seemed to fix the hole pattern problem. There are a few other glitches in the Wizard that I've ran in this latest version, i.e. green preview screen, wouldn't approach correctly while trying to cut an outside circle. Would "spazz" out and lose steps, then continue on with the G-code. This happened after pressing the ESC botton to stop the previous program. Then the two issues mentioned above happened. These were minor, but worth mentioning, just in case anyone else has ran into these problems. WgE.