Hello Guest it is March 28, 2024, 08:03:55 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - salvanosalvador

Pages: 1
1
General Mach Discussion / Re: Mach weak output help
« on: May 02, 2012, 03:01:03 PM »
my driver is full step and half step resolution only hood

2
General Mach Discussion / Re: Mach weak output help
« on: April 29, 2012, 01:31:47 PM »
I really need your help

I have 1.8d stepper with a 200 s/r and a 2.8 A/phase.

I just wanna try the motor without any mechanical drive connected.

I don't know how to calculate Steps Per Unit and acceleration and velocity.


( this morning I tried to increase the velocity rate and the LED is more Bright but No effect on the Motor shaft)

3
General Mach Discussion / Re: Mach weak output help
« on: April 29, 2012, 04:51:07 AM »
is this in motor tuning

4
General Mach Discussion / Mach weak output help
« on: April 28, 2012, 10:40:14 AM »
I am trying to drive one stepper and I connected the circuit and tested it using the Breakout board software, the motor spins perfectly but with Mach3 the axis pul LED in the BB just have a dim light and the motor don't spin >>>>I think it is the output signal from mach so How can I change it?

Help PLEASE

Pages: 1