Messages

1

General Mach Discussion / Re: New to Mach3

« on: April 08, 2012, 09:34:52 PM »

go to the diagnostics page and look for a limit switch or other light on (that is not ment to be on) :idea:

2

FAQs / Re: Mach3 does not respond to jogging or running G-code

« on: April 07, 2012, 11:11:33 PM »

Hi team,
I have installed Mach 3 on a XP  system (Ive been using turboCNC with no problems) I have all the pins and ports set the same as I had with turbo, but the mill seams to be "dead"!
Now when I say "dead" that is not quite true, When I use the jog keys the led's on my driver board light up to say the axis is moving but the motor is dead!
I have been into the motor settings and moved the two sliders from one extreme to the other and had the same result(I have also upped the pulse setting). I'm sure it is a setting that I have wrong, I just cant find it!