Hello Guest it is March 28, 2024, 06:46:31 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - motocrossmann

Pages: 1
1
What?   Free???   How can that be?   I will definitely check it out.

2
I'm a home hobbyist who has recently rigged up my little 3-axis mill with Mach3.   I have access to a legit version of Solidworks by virtue of the work I do, but I do NOT have access to any CAM software.   As a hobbyist, all the decent CAM software that can work with Solidworks costs some serious $$$.   What would you guys suggest?   I'd be willing to spend as much as $200, but that is orders of magnitude off of what most CAM companies want.   What say ye???    I'm not interested in using pirated software.

3
General Mach Discussion / Re: Jog arrows are backwards
« on: March 24, 2012, 11:40:43 PM »
Nevermind fellas.   I'm stinking this place up with NEWBNESS.    I just needed to reverse some stuff in my pins and ports settings.   Thanks for the advise ger21!

4
General Mach Discussion / Re: Jog arrows are backwards
« on: March 24, 2012, 11:02:49 PM »
Sorry to be a newb, but does that mean I wired something wrong, or can I change my ports & pins settings to get this right?

5
General Mach Discussion / Jog arrows are backwards
« on: March 24, 2012, 10:35:45 PM »
Is there a way to reverse the way the arrows appear on the jog dialog?   I was able to reverse the directions to get + and - to be the correct directions, but the arrows on the jog dialogue are backwards.   I need the left x-axis arrow to be + and the right x-axis arrow to be -.

6
Hi Everyone.   I'm new to CNC, but have done some old school mill work in the past.   I just converted my Roland CAMM3 to Mach3 control and am looking forward to figuring this stuff out!   Sorry for the newb questions in advance!

Pages: 1