1
Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!
« on: March 29, 2012, 03:09:45 PM »
Hi everyone,
I am a new member just joined recently and I am from Singapore. I recently construct a profile machine with 3-axis, intended to use it to produce Printed Circuit Board. I found Mach3 software very elegant but have no ideas how to connect them on parallel port to the servo-motor driver electronic running WinXP. Although I have check through the Mach3 manual but still electrical connection is no where to be seen. Can member suggest some procedure to it.
Edmund Tay
I am a new member just joined recently and I am from Singapore. I recently construct a profile machine with 3-axis, intended to use it to produce Printed Circuit Board. I found Mach3 software very elegant but have no ideas how to connect them on parallel port to the servo-motor driver electronic running WinXP. Although I have check through the Mach3 manual but still electrical connection is no where to be seen. Can member suggest some procedure to it.
Edmund Tay