Hello Guest it is March 29, 2024, 08:24:45 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - paulsukes

Pages: 1
1
 Kilroyjones ;
Have you looked at the wizard in Mach3 . There are about 10 different fonts available . One of them may be similar to Arial and you can place them
at any location and size.... Paul W

2
General Mach Discussion / Re: Question... G54 default fixture offset ?
« on: March 29, 2007, 04:53:57 PM »
 :) Thanks Hood . This fixed the problem .  I also thought that I could Home the machine and zero
out the DRO's and then goto the offset page and select the fixture offset (in my case G54), but zeroing the
machine sets the G54 to zero . thanks again Paul W

3
General Mach Discussion / Question... G54 default fixture offset ?
« on: March 29, 2007, 04:12:43 PM »
 ???
Hi Ya'll ;

I am running Mac3 ver 2  60 . When I startup mach and go to the offset page , all my fixture offsets are correct   except G54 (which is all Zero's) .
Is this because after homing the machine G54 is set to 0,0,0 by default ? If so , how can I work around this ?

Great group.... Paul W

Pages: 1