Messages

1

General Mach Discussion / Re: New license

« on: May 14, 2012, 03:55:59 AM »

Thanks Gerry, I set up from scratch and its working fine, as you say I must of changed something? anyway all good now, Cheers mate.

2

General Mach Discussion / New license

« on: May 13, 2012, 03:59:56 AM »

Hi all, I have had Mack3 for a wile now and have just paid for my license and now I have no stepper motor movement, the software still shows movement, I had a look in Device Manager - ports , and found that there is a new Printer port  (LPT1) so “if” this is the problem how do I set it up? Before adding the license it was working fine.