Messages

1

Galil / Re: Galil controller compatability (what works with the plugin)

« on: July 14, 2017, 07:22:59 PM »

Any progress on a demo license for the mach4 plugin? I have been using Mach3 with a DMC-1880 for a few years and have some time to play with Mach4 upgrade (demo).
I know it is not supported but I have tested contour mode with the DMC-1880 and it has worked smooth. It did conflict with my probing macros, that's why I thought it would be good to test on a fresh install of Mach4.
Thanks,
Jon

2

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: October 30, 2015, 08:53:14 PM »

Ger,
I have been using 2010 for some time. I recently wanted to add a tangential knife to my CNC. I notice the button on the standard Mach3 screen but can't find it in 2010. Was this eliminated from 2010? Do you know what script is required or a way for me to find out?
Thanks

3

Galil /

« on: January 08, 2015, 10:37:57 PM »

Not sure if this is the same thing I experienced this weekend but sounds similar I am running a dmc-1880, everything has been running perfect for more than two years. Then I decided to update the plugin to the latest. (4.6) and galiltools driver, all axis would only jog right, jog left, no movement and an error message. When jogging right my dro did not change. Finally I went back to galil plugin (4.4) and ver7 drivers and everything returned to normal the latest update may have left PCI cards in the dust.