1
Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!
« on: November 01, 2014, 12:02:47 PM »
Hi Everyone I am not sure where to post this, I am using qcad and sheetcam and of coarse Mach3 on my cnc table.
Up until last night I haven't had a problem but I designed a file last night and set it up in sheetcam like normal and just like always it went great and it was a very quick and easy file. Just one .25 in hole to drill and a 1.01575 dia recess .12 inch deep spiral cut. After posting it I opened in mach3 and nothing, it loads but nothing in the screen but a little dot which I could not enlarge. Only thing I did on that computer was add a xbox 360 wired controller. I designed it on a different computer and posted on the one I designed it on, went in shop and used mach3 there. After doing that and the problem I tried loading on all 3 computers and didn't work. All old programs opened fine but now any new files I create wont show in mach3. Not sure what happened. I have unplugged the xbox controller but not remove plugin yet.
Thanks for any help if you have any ideas.
Ed
Up until last night I haven't had a problem but I designed a file last night and set it up in sheetcam like normal and just like always it went great and it was a very quick and easy file. Just one .25 in hole to drill and a 1.01575 dia recess .12 inch deep spiral cut. After posting it I opened in mach3 and nothing, it loads but nothing in the screen but a little dot which I could not enlarge. Only thing I did on that computer was add a xbox 360 wired controller. I designed it on a different computer and posted on the one I designed it on, went in shop and used mach3 there. After doing that and the problem I tried loading on all 3 computers and didn't work. All old programs opened fine but now any new files I create wont show in mach3. Not sure what happened. I have unplugged the xbox controller but not remove plugin yet.
Thanks for any help if you have any ideas.
Ed