1
General Mach Discussion / Re: Plasma - Handling misaligned materials - G68 does not work
« on: February 29, 2012, 07:52:06 PM »
TP, sorry for the delay in updating the status of the my post. I already tried your suggestion and it worked. I can't thank you enough.
I can now use G68 in Mach without having to deal with the trouble of aligning the material precisely to the table's axises. What a relief!
THC 300 post processor seemed to work fine as well without any major changes. All I have done was to add Z switch offset value to mach my floating head switch offset.
You mentioned that using G31 also has problems. What kind of problems should I anticipate?
Thanks in advance...
I can now use G68 in Mach without having to deal with the trouble of aligning the material precisely to the table's axises. What a relief!
THC 300 post processor seemed to work fine as well without any major changes. All I have done was to add Z switch offset value to mach my floating head switch offset.
You mentioned that using G31 also has problems. What kind of problems should I anticipate?
Thanks in advance...