Messages

1

SmoothStepper USB / Re: Ethernet SmoothStepper first test

« on: April 04, 2012, 11:40:48 AM »

Looks like your "lost in Space"
 

2

SmoothStepper USB / Re: Ethernet SmoothStepper first test

« on: February 15, 2012, 08:33:00 AM »

thanks rcaffin will look into it on my system just waiting for better weather kinda cold in the garage but I am changing out the older USB smoothstepper with the Ethernet one since I have had intermittent stops due to noise that no matter what I tried it would not go away and the newer version is suppose to be more noise resistant(that and I have a c25 breakout board too)....
I think the plugin for the ess Needs a little more evolving but it's looks close enough for me so far..

3

SmoothStepper USB / Re: Ethernet SmoothStepper first test

« on: February 11, 2012, 10:46:25 AM »

rcaffin can you show where you increased that buffer by a screen print i can't seem to find it..
i am using version 10da2 of the ess pluggin..thanks

4

SmoothStepper USB / Re: Ethernet SmoothStepper first test

« on: February 08, 2012, 08:33:10 PM »

If this is the wrong area to post let me know (i am new here)..
I just received the Ethernet smooth-stepper..my question is I have also bought a break out board for i/o that physically slides onto port 1 and 2 of the smooth stepper..
I want to use port three as my port that goes to my gecko g540 is this possible or do i have to remain on port one(thus making my breakout board unusable)...
the break out board is a :   
C25 - Smooth Stepper Terminal Board from CNC4PC..
I am hoping i just have to set the step port and dir port in "ports and pins" to 3 and 3 thus setting it to port three..
and maybe setting pins 2 thru 9 in the smooth-stepper to outputs(again in the smooth-stepper plugin config) on the port three ..