1
General Mach Discussion / Re: No Y axis movement Easy Loader Plasma table
« on: February 09, 2012, 05:57:00 PM »
I noted when I looked at the drivers, that the Y driver was connected to the 6 and 7 block. So, since it was not working, tried moving the 4 and 5 terminal block and now it works! So whomever set this up, did it in-correctly.
Thanks for the help. Without the clue to try using expected pins, I would not have tried switching.
Thanks for the help. Without the clue to try using expected pins, I would not have tried switching.