Hello Guest it is October 28, 2020, 01:14:15 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bizzz3

Pages: 1
1
I'm upgrading from V2.6 to V3.043.062 and for some reason the DRO'S move but the steppers don't move.
I can switch back to V2 and they move.
The ports and pins have been set up identical of course.
With the exception of the limit switches, I disabled them until I figure this out.
 
I noticed the Mill3 xml file is formated totally different than V2, so I created a new profile.
So there is something I am missing and I can find nothing different in the V3 setup docs.

I'm using ESS smooth stepper with updated plugin and have proper status led's.
When I start V3, I do hear the steppers grab, that familiar clunk sound. But usually the ballscrew is unmovable, here I can actually turn them by hand with some effort.
I tested communication with the BOB by enabling a limit switch and see it come on in the Diagnostics screen.
So I guess I am getting no pulses.
I don't have a clue where to look next.
Included is my config file.
Someone out there seen this kind of issue?

2
G-Code, CAD, and CAM discussions / Re: Mach3 missing DXF import.
« on: February 19, 2012, 07:28:19 PM »
my 64 bit xp machine ran mach3 just fine. Then after a week the hard drive crashed and couldn't find some LTRD file to start up windows, so i re-installed xp and mach would not ever run again. So i got a $25 craigs list 32bit machine and all is good again. Puzzles me why it worked in the first place, all the forum posts said it wouldn't, go figure.

Pages: 1