1
General Mach Discussion / Re: Problem engraving - depth changes
« on: May 03, 2013, 01:38:45 AM »
Thanks, not rubbish at all!
I did find what I think is a solution.
Within Mach3 I adjusted the acceleration for the z axis to 2.
Still needs further testing, but so far the results are good.
I'll post more results later.
thanks for all the help!
I did find what I think is a solution.
Within Mach3 I adjusted the acceleration for the z axis to 2.
Still needs further testing, but so far the results are good.
I'll post more results later.
thanks for all the help!