Hello Guest it is March 28, 2024, 07:28:49 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gordy

Pages: 1
1
General Mach Discussion / Re: Trouble getting started again
« on: January 23, 2012, 01:58:02 PM »
I just ran it under another Mach 3 program (didnt work last night) and it started up! I didnt change any settings from earlier so i dont know if i have a dodgy connection, but hopefully it stops acting up

2
General Mach Discussion / Re: Trouble getting started again
« on: January 23, 2012, 01:49:53 PM »
Thanks Russ illl take a look at it, but the Program wont run that far.


3
General Mach Discussion / Re: Trouble getting started again
« on: January 23, 2012, 01:12:59 PM »
Hey thanks for the reply im sorry i made a mistake in my post the top lines of the code i am runnig are:
T1M6
G17
G0Z2.0000
G0X0.0000Y0.0000S12000M3
G0X0.3750Y0.3820Z0.2500
G17-0.0007F10.0

I used Aspire and this is the code it came up with, the machine stops at G0Z2.0000 and in the diagnostics OUTPUT 5 is lit up. Last night i deleted that step and then it stopped at the next line G0X0.375Y0 etc... Its not touching any limit switches and i checked the configuration in Mach 3 and no errors were found.

Gordy.

4
General Mach Discussion / Trouble getting started again
« on: January 22, 2012, 08:27:46 PM »
Hi there I'm relatively new to this so forgive my ignorance have recently run into a problem while trying to run any of my G Codes. They all ran smoothly last summer, but i have since built a new table and moved the Router. My problem is that whenever I try to run the program it stops at Line 2 "GOTOZ2.0000" and at the diagnostic screen output 5 flashes. I was just exploring and deleted this step, but then it stops at the next line, moving 7 inches along the X axis and stopping giving me only an output 1 and output 5 errors. I ran a test run with no bit on the same G Code last week and it ran just fine so I'm at a loss, Any help would be greatly appreciated,
Gordy


Pages: 1