Messages

1

General Mach Discussion / Re: Hi. Need help with x axis losing position.

« on: December 26, 2012, 01:57:15 PM »

Hi again,

Here's the XML file

2

General Mach Discussion / Re: Hi. Need help with x axis losing position.

« on: December 26, 2012, 01:24:26 PM »

Hi Hood, Thanks for your help. I 'm in little trouble here. It appears that my machine has 3 different XML's for mach mill. I don't know which one is currently in use. May you tell me how to tell which one is the one?

Thanks again,

Giaccomo Alvarez.

3

General Mach Discussion / Hi. Need help with x axis losing position.

« on: December 21, 2012, 01:25:08 PM »

Hi everybody. I own a Sicono CNC machine, that works well on certain jobs, but when I load a heavy file (usually a finish pass with a very small cutter say, 0.3 mm) sometimes the machine will lose it's x position and start to cut on an erroneous part of the table. This has caused to break a lot of cutters, not to mention all the lost material. May you help me diagnose this situation, to get it straight? I am attaching one file that has showed this behavior.

Thanks a lot in advance.

Giaccomo Alvarez. D.I.

p.d. On the photo attached, you may see the roughing on the right (correct position) and on the left the finishing (shifted to the left).