1
General Mach Discussion / Re: Re: Mach3 setting and configuration (newbie question level )
« on: February 07, 2012, 11:56:36 AM »
Thanks for your help "fastest1"!!!! I appreciate it. On the diagnostics page, when I press my estop buttons the green lights indicate that they are definately working, but when I run into them with my gantry it doesn't stop anything. Also there an estop switch located on my plasma torch head assembly, which is used for telling my head to stop when it reaches the material. That also doesn't work for some reason if thou the diagnostics says it does, therefore I havta babysit my table and hit the "page-up" button on my keyboard each and everytime the head comes down. Any sugghestions??? Thanks for your time. My company and I appreciate it.