Hello Guest it is March 28, 2024, 08:11:35 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - avcasting

Pages: 1
1
General Mach Discussion / Mach 3 G-Code conversion
« on: January 17, 2012, 03:35:23 PM »
Hey everyone. I'm having a huge problem. I use artcam and when I build my g-code, everything works great. But now, I lost my file completely from Artcam and I was hoping that there is a way to convert my G-Code into something else. Any type of vector file.

2
General Mach Discussion / Re: Jog Screen Help
« on: December 23, 2011, 11:41:48 AM »
I already did that. I want the jog screen to stay no matter what. If i click settings, I dont want to return to the main screen and hit TAB to open it again. I want it to stay there. Thanks!

3
General Mach Discussion / Jog Screen Help
« on: December 23, 2011, 11:07:11 AM »
Hey guys, i got the jog screen positioned where i want it. and it stays there every time i hit tab. I'm trying to find out if there is an option to keep it there. Every time i hit settings or go to another screen, I have to hit tab to open it again. Is there a way to just keep it there? Thank you!!!!

4
General Mach Discussion / Screen Help
« on: December 22, 2011, 10:52:01 AM »
Hey guys, i'm trying to figure out how I can adjust my screen so that when I press tab and adjust that side of the screen, it will stay like that always. Please help me. Thanks!

5
General Mach Discussion / Re: A Axis HELP
« on: December 19, 2011, 11:05:33 AM »
For some reason I have movement, I just don't have the movement in degrees. I don't know what ports and pins to activate it on. I have no clue what to do.

6
General Mach Discussion / Re: A Axis HELP
« on: December 19, 2011, 10:37:59 AM »
Hey, so im attaching the file. I don't know what a link is. I'm sorry.

7
General Mach Discussion / Re: A Axis HELP
« on: December 19, 2011, 10:28:29 AM »
To be honest, I don't know what it is. I don't know anything about gearing between motor and output. I can send you an xml but I don't know where to get it. All i know is that I have a reset button and a bunch of G-Codes that I just let run. Aside from that, I have no clue.

8
General Mach Discussion / A Axis HELP
« on: December 19, 2011, 09:36:27 AM »
Hey guys, I'm trying to figure out what's wrong with my A-axis. It moves in a circular motion and a circle is 360 degrees. Everyone knows that except for my mach. It goes up to 14 and some decimals. Please help me out with this. It would be very much appreciated. I just want to know how to set it so i can see how many degrees its turning. Thanks Everyone!

Pages: 1