Hello Guest it is March 28, 2024, 11:38:41 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - aussihorologist

Pages: 1
1
General Mach Discussion / Re: Spindle start up causes mach3 estop
« on: December 17, 2011, 03:35:42 PM »
Thank's so much Hood.....that worked great! Merry Christmas to you and All.

2
General Mach Discussion / Re: Spindle start up causes mach3 estop
« on: December 16, 2011, 04:48:19 PM »
Hi Hood, thanks for responding, but I can't find a where 'SS'  and a 'filtering value' are in Mach - I looked in Spindle Setup but can't see it, could you please spell it out for me?

3
General Mach Discussion / Spindle start up causes mach3 estop
« on: December 15, 2011, 08:24:20 PM »
Hi, I need some help with my syil X5 2011 setup. The spindle start up (eg S1000 M03) makes the spindle go to speed (around 1350 rpm) but causes mach3 to throw an estop at the same time. I've tried changing most of the settings in Mach3 but no luck yet. I'm using the SmoothStepper interface. The Spindle is tuned 100/1200/800. The spindle starts in manual mode without error. Any suggestions would be appreciated. I'm very new to this stuff so simple explanations are good!

I've read a thread about VDF noise/grounding causing estop issues but I'm not running a VDF motor.

Pages: 1