Messages

1

Galil / Re: Galil controller compatability (what works with the plugin)

« on: January 19, 2012, 03:20:36 AM »

The mach runs well if the output is a parallel port.
The mistake comes forward only with the galil.

apukak

2

Galil / Re: Galil controller compatability (what works with the plugin)

« on: January 17, 2012, 10:21:22 AM »

I tried the new plugin, but nothing's changed, the system stutters. (cca. 400ms is period.)The mach is very occupied.  Repeatedly push the STOP button  in order for the machine to stop.

3

Galil / Re: Galil controller compatability (what works with the plugin)

« on: December 29, 2011, 06:40:29 AM »

There are not motors, only pc and Galil.
The standstill shows on the dro cca. 3-4mp until time.
The standstill shows on the single axes in a dmc smart terminal.

4

Galil / Re: Galil controller compatability (what works with the plugin)

« on: December 29, 2011, 06:09:20 AM »

Thank you!
GALIL is at step mod. The pc is connect only on galil, there are not end switches.

5

Galil / Re: Galil controller compatability (what works with the plugin)

« on: December 29, 2011, 03:44:21 AM »

Help me!  I use Mach3 + GALIL 2230 .
Everything works well but I have a problem:
300000 line are G-code of program. His
starts jamming on middle of program and this intensifies.
Processor run on 60-70% power.
In debug program of GALIL plugin T=4.********* or bigger.
Small program (2000 lines) is ok, no jamming.
What is problem?
Thenks!

6

Galil / GALIL 2230

« on: December 12, 2011, 05:16:13 AM »

Help me!  I am useful Mach3 + GALIL 2230 .
Everything works well but I have a problem:
300000 line are g code of program. His
starts jamming on middle and this intensifies going on.
Would I ask what may be the mistake?
Thenks!