Messages

1

General Mach Discussion / Re: Problem with homing Z

« on: December 09, 2011, 09:07:45 AM »

Thanks for advice. i have increased debounce as suggesred and it worked. Thanks again.

2

General Mach Discussion / Problem with homing Z

« on: December 08, 2011, 07:50:10 AM »

I am new to this forum. I am in the process of setting up the new CNC router that I just build. After tuning all the motors and have them jog from the keyboard I have set and connected homing switches for all three axes. when I try to home using Home All the X and Y go to limits backs and zero but Z moves little change led to green and stops without touching limit. When I try to reference from diagnostic screen it does the same.
Please Help