Messages

1

dspMC/IP Motion Controller / Re: DSPMC/IP V2 using more inputs and outputs than defined in MACH3

« on: December 26, 2011, 01:24:32 AM »

Thanks for info, looking forward for new plugin.
However now I am very interested in dspmacro implementation, as to my understanding it can add lots of powerful options for automation.
Can mr. Rufi give me some info or direct me to documentation on how to upload dspmacro written in basic to the dspmc.

Wapayk

2

dspMC/IP Motion Controller / Re: DSPMC/IP V2 using more inputs and outputs than defined in MACH3

« on: December 25, 2011, 04:05:48 PM »

Thanks for reply, I have considerable knowledge on plc and modbus programing, but I bought dspmc with 64 inputs and 32 outputs just because it has so much functions and it eases retrofiting of any machine and now I can't use all inputs because there is no reference how to use it so I am asking someone who knows how to, to help me out.

So I need short guide how to upload dspmacro to dspmc/ip or how to extend number of inputs in macho3 so I can dedicate them to dspmc inputs.

3

General Mach Discussion / Re: Mach3 and DSPMC/IP V2 using inputs and outputs

« on: December 25, 2011, 05:52:33 AM »

thanks Hood, I posted on DSPMC forum section, maybe guys from Vitalsystem can help me there.

Wapayk

4

dspMC/IP Motion Controller / DSPMC/IP V2 using more inputs and outputs than defined in MACH3

« on: December 25, 2011, 05:33:46 AM »

Hi all,

I am retrofitting old Shinx CNC with two tables and seven pneumatically controlled spindle motors. Each pneumatic cylinder has two sensors for detection of up and down state so that counts to 24 sensors on the machine plus limit switches, zero and MPG inputs.
I have used all of MACH3 inputs and now I need 12 more. I have break out board with rest of the inputs as DSPMC/IP supports 64 inputs

My question is how can I use rest of the DSPMC/IP inputs and outputs?

I looked at DSPMacro but don't know how to program it in DSPMC and couldn't find any info on that matter.


Wapayk

5

General Mach Discussion / Re: Mach3 and DSPMC/IP V2 using inputs and outputs

« on: December 24, 2011, 04:20:01 PM »

Thanks for reply,

I know how to use brain and macros, however I don't know how to interface inputs on DSPMC/IP that are not defined in ports and pins in MACH3 because all inputs in ports and pins are used and I have 24 more inputs on DSPMC.

regards
Wapayk

6

General Mach Discussion / Mach3 and DSPMC/IP V2 using inputs and outputs

« on: December 24, 2011, 10:00:55 AM »

Hi all,

I am retrofitting old Shinx CNC with two tables and seven pneumatically controlled spindle motors. Each pneumatic cylinder has two sensors for detection of up and down state so that counts to 24 sensors on the machine plus limit switches, zero and MPG inputs.
I have used all of MACH3 inputs and now I need 12 more. I have break out board with rest of the inputs as DSPMC/IP supports 64 inputs
My question is how can I use rest of the DSPMC/IP inputs and outputs for that matter?

Would be grateful  if some kind expert can help me.
Wapayk