Hello Guest it is August 19, 2019, 08:43:08 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bofee

Pages: 1
1
General Mach Discussion / Re: Mach3 causing computer to restart.
« on: November 29, 2011, 04:04:34 PM »
I ended up re-installing Windows and Mach3 is running OK. I may never know the details of what was causing the computer to re-boot.
Thanks for everybody's help.

2
General Mach Discussion / Re: Mach3 causing computer to restart.
« on: November 25, 2011, 11:51:30 AM »
Nope, no apparent problems on reboot.

3
General Mach Discussion / Re: Mach3 causing computer to restart.
« on: November 24, 2011, 01:16:39 PM »
I will look at all the above. There is also a section in the manual (2.4 Installation Problems) that describes what I am seeing.

4
General Mach Discussion / Re: Mach3 causing computer to restart.
« on: November 23, 2011, 07:45:42 PM »
The computer is a 3Ghz Pentium 4, CPU is running at 25 Deg C. The hard drive is about 10% full and checks out clean for errors. Upon restart I'm getting a message,"System has recovered from a serious error."  I can't even run the driver test app because the computer reboots when Mach3 takes over.

5
General Mach Discussion / Mach3 causing computer to restart.
« on: November 23, 2011, 04:19:42 PM »
I'm just getting started with Mach3 on a CNC router build. I had basic functions working a couple of days ago with the Gecko G540 configuration installed. Today everytime I load Mach3 my computer reboots. I disconnected everything and reloaded the software, no help.
Anybody have suggestions?
Thanks

Pages: 1