Hello Guest it is March 28, 2024, 07:22:48 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - AndreasT

Pages: 1
1
General Mach Discussion / Calibrate Spindle
« on: January 10, 2013, 02:44:25 AM »
Hi!

I wonder if there is possible to adjust the auto calibrate linearation curve manually after the the procedur has been done.

/Andreas

2
General Mach Discussion / Re: Time to show off my ATC
« on: December 30, 2012, 12:03:15 PM »
Thanks for your answers, how about the shot pin arrangement for spindle orientation? Pictures would be great, since i can´t see it on the other pictures?

3
General Mach Discussion / Re: Time to show off my ATC
« on: December 29, 2012, 02:22:51 PM »
What type of pull stud do you use with ball gripper? 45deg?
I'm using 45 deg from ctc toolz and have clear marks with less force than you.. Hmm

4
General Mach Discussion / Re: Time to show off my ATC
« on: December 29, 2012, 05:04:56 AM »
Hi!

Really good worked, look really nice! I´m building my own ATC and BT30 gripper system right now so input for you would be great.

Regarding the drawbar and gripper, did you make it yourself and do you have picture of it? What ballsize do you use?
I have build a 6x5mm ball gripper but I get dents on the pullstud (using 45deg) and don´t know if this is normal since it could affect runout I assume.
I´m using about 800pounds of force from bellevilles springs.

I also have a VFD with 2 pole 3-phase engine and planing to use index signal to orient the BT30 holder. Can you provide more detail about the shot pin, picture of it would be super?

BR/Andreas

Pages: 1