Hello Guest it is March 29, 2024, 11:48:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - thoroughcuts

Pages: 1
1
General Mach Discussion / CNC Plasma Starts firing and stops
« on: November 13, 2011, 08:59:38 PM »
I have an ez router CNC plasma system with Mach 3. I load my G code the torch goes to the starting point then just stays there and fires into the metal but does not move. I have tried different g codes thinking it was in the coding, but to no avail. Checked port 1 in the diagnostics and it showing some of the pins green but not all of them. I am unsure if this has something to do with it or not. Would love to get an answer before I have to call EZ router to find the answer. I am a newby at this so bare with me ::)

2
Hello, I am a newby to all this. Located this forum hoping it will help me on this new adventure. I purchase a 4x8 ez router cnc plasma system. Using Cut2D software and Mach, I work on computers for a living, but have never done a anything like this. Just hoping to gain more knowledge from this forum

Pages: 1