Hello Guest it is March 28, 2024, 05:42:14 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Rudolff

Pages: 1
1
General Mach Discussion / Re: Motors not responding
« on: November 29, 2011, 02:42:33 PM »
According to your Mach3.xml PulseWidth is 0 (zero). It must be 1 to 15 microsecond. Config/Motor Tunning! Don't check DirLowActive in Motor Outputs. Must be red.
Regards!
Rudolf

2
General Mach Discussion / Re: Help getting my machine running...
« on: November 29, 2011, 02:31:13 PM »
Motortunning ! Probably PulseWidth is 0(zero). Must be 1 to 15 microsecond.
Regards.
Rudolf

Pages: 1