Messages

1

General Mach Discussion / Re: Scandinvent C4 cnc running Mach 3

« on: October 18, 2011, 09:49:22 AM »

Yes it does?

2

FAQs / Re: Scandinvent C4 running Mach 3 controller

« on: October 18, 2011, 09:47:42 AM »

Yes the Yard is in Braintree. (CM7 5LS)
E-mail Contact@doreward.com
mobile - Kirk - 07809410480.

give us a call if you think you can help.

3

General Mach Discussion / Scandinvent C4 cnc running Mach 3

« on: October 17, 2011, 03:47:04 PM »

Hi.
I have a granite and marble company and have recently purchased a 2nd hand Scandinvent C4 CNC machine. Unfortunatley I am struggling to find anyone/info that will help me run the machine. The machine came with an instructors manual and the boys in the yard have managed to cut out a few sinks but have come across several stubbling blocks along the way i.e Tool tables, g-codes and scaling. I have looked on the internet for advice but can't seem to find anything. What i am looking for is someone who can spend a day or two, to show the full working capabilities of the machine to the boys in the yard. Any feedback will be much appreciated.

4

FAQs / Scandinvent C4 running Mach 3 controller

« on: October 11, 2011, 09:54:49 AM »

Hi.
I have a granite and marble company and have recently purchased a 2nd hand Scandinvent C4 CNC machine. Unfortunatley I am struggling to find anyone/info that will help me run the machine. The machine came with an instructors manual and the boys in the yard have managed to cut out a few sinks but have come across several stubbling blocks along the way i.e Tool tables, g-codes and scaling. I have looked on the internet for advice but can't seem to find anything. What i am looking for is someone who can spend a day or two, to show the full working capabilities of the machine to the boys in the yard. Any feedback will be much appreciated.