Guest
Show Posts
1
General Mach Discussion / Hardware drivers
« on: October 11, 2011, 09:14:01 AM »
Hello everyone,
I am JeanSir in South Korea.
I have a milling machine controlled by mach 3 software. Few day back the software corrupted.
I formated my computer and reinstalled again the software.
I already have backup with me for the hardware (Mach-PP2).
Now I am facing a problem of communication between software and hardware ( 3 axis for stepper motor are not moving).
I have the datasheet for Mach PP2 everything is done as advised.
I checked in another computer with same program and it looks like I don't have Mach 3 drivers.
Please anybody can advise me where to find mach 3 drivers?
Thank you in advance.
JeanSir
I am JeanSir in South Korea.
I have a milling machine controlled by mach 3 software. Few day back the software corrupted.
I formated my computer and reinstalled again the software.
I already have backup with me for the hardware (Mach-PP2).
Now I am facing a problem of communication between software and hardware ( 3 axis for stepper motor are not moving).
I have the datasheet for Mach PP2 everything is done as advised.
I checked in another computer with same program and it looks like I don't have Mach 3 drivers.
Please anybody can advise me where to find mach 3 drivers?
Thank you in advance.
JeanSir