Messages

1

General Mach Discussion / Re: calibration probems

« on: October 13, 2011, 04:48:42 PM »

This helped some, but we are seeing a change in "z" each time we run our program of about .025". Is there something in the code or in the offsetts in Mach 3 that would cause this?

2

General Mach Discussion / calibration probems

« on: October 06, 2011, 02:06:14 PM »

We are attempting to repeat the same part located on a fixture using a router and Mach 3. It seems that we are getting "creep" in the "0" location with each run of the program. Is this a program problem or  a setting in Mach 3? Can someone please help?