Guest
Show Posts
1
FAQs / Can a power dip cause malfuntion in the cutting sequence?
« on: October 05, 2011, 07:39:36 AM »
A nubie!
Our system was running fine, but then we had a power dip, and the machine stopped before it was able to finish. The computer went to blue screen. After restart of Mach3, we noticed our cutter has been cutting to the left, after about 3/4 down our cutting line. Our dimensions of home position and end position has not changed and is correct, however the cutting is veering off it's line, we have not changed anything in the software set up.
What could be causing this? is there a corruption in the drivers?
Our system was running fine, but then we had a power dip, and the machine stopped before it was able to finish. The computer went to blue screen. After restart of Mach3, we noticed our cutter has been cutting to the left, after about 3/4 down our cutting line. Our dimensions of home position and end position has not changed and is correct, however the cutting is veering off it's line, we have not changed anything in the software set up.
What could be causing this? is there a corruption in the drivers?