Hello Guest it is March 28, 2024, 10:51:33 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Balhousie

Pages: 1
1
General Mach Discussion / Re: Help with Motor Tuning
« on: October 11, 2011, 11:41:24 PM »
When I reset my micro steps i had to reset my StepPerMinute setting in the setup page. I'm guessing this is your problem.
Regards, tonyNZ

2
General Mach Discussion / Re: New to CNC, Need input please
« on: October 04, 2011, 07:44:37 PM »
Hi Mike, Same problems here! I found these very useful

 http://www.machsupport.com/videos/

Regards, Tony

3
Hi Folks, A new member, from New Zealand.

 My name is Tony. I am an amateur everything. I build (stringed) musical instruments, collect and restore vintage motorcycles and most things with an engine. Do my own paint spraying, panel work and mechanics. Build furniture, wood and metalworking machinery and have just (almost) built a CNC router and hope to convert my mill next.

I'm (almost) completely confused (nothing new there then) by the whole business of Cad/Cam/Mach but beginning to see a glimmer of light.

Regards, TonyNZ


4
I bought motors and board kit from HobbyCNC....if you don't mind doing a bit of soldering yourself.

Regards, TonyNZ

Pages: 1