1
General Mach Discussion / Re: New Computer, now stepping problem
« on: September 29, 2011, 03:59:57 PM »
Well here is the solution. I find it odd...
With the new computer the velocity and acceleration was too fast. It must have been the old computer could never meet those limits because of CPU speed so the machine ran fine. With the new faster computer I had to cut the accel in 1/2 and reduce the velocity from 100 to 75 ipm.
With the new computer the velocity and acceleration was too fast. It must have been the old computer could never meet those limits because of CPU speed so the machine ran fine. With the new faster computer I had to cut the accel in 1/2 and reduce the velocity from 100 to 75 ipm.