Hello Guest it is August 08, 2020, 11:14:16 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - mecanizadosgv

Pages: 1
General Mach Discussion / servoconfig settings Dugon drives...
« on: September 27, 2011, 05:53:14 PM »

Hello everyone ...
 I have a new control of my milling machine. DUGONS has 3 units. Actually, I'm trying to configure the system, but the chart servoconfig is not similar to a data sheet dugon. However, I have been varying factors such as Ai, Li, etc, but does not improve .... only reduces the value of error display, but the wave remains the same

 Is there any method or approach to calculate the actual values ​​to adjust the DC motor.
DC motor is the brand SIEMENS 1HU ...
 and encoder, I bought one in www.cnc4pc.com .....................

Pages: 1