Messages

1

General Mach Discussion / Re: Gerber files to G Code

« on: September 18, 2011, 04:12:17 PM »

It could be Eagle but it can vary as I am trying to help a number of people who want a low end CNC router for PCBs. In some cases it would Altium Designer and I have a license of that so will check and see if it can. Thanks for the help.

Steve.

2

General Mach Discussion / Re: Gerber files to G Code

« on: September 15, 2011, 07:45:31 PM »

Thanks TP. I think my question would then be, "How do you convert a Gerber file to a G-Code file". If I could do that, then I would be able to solve this problem.

Many thanks,

Steve.

3

General Mach Discussion / Re: Gerber files to G Code

« on: September 15, 2011, 07:15:43 PM »

Thanks Rich. Lets see if there are any other ideas out there 

4

General Mach Discussion / Gerber files to G Code

« on: September 15, 2011, 04:48:09 PM »

Hi,

I am think of using a router that uses Mach3 to control and would like to know if the software can import Gerber files. The use would be for PCB prototyping and there are a fw gerber files that need to be imported. They are a top layer, botom layer, drill file and keep out layer.

Any ideas?
Many thanks,

Steve